Industry knowledge

The edge wear of conveyor belt is mainly the physical wear of belt edge and frame when the conveyor belt deviates. The conveyor belt body should run on the center line of the idler group. The defects in the installation and use of the conveyor often lead to the deviation of the conveyor belt body from the center line.

Generally, the deviation of the conveyor belt in the width direction is allowed to be 5%. When it is greater than this number, the conveyor belt may contact with the idler support and frame, resulting in edge rubber wear. In case of serious deviation, it may even turn over the edge of the conveyor belt, such as the radial travel screw head of the drum, the cleaner stop and other convex parts, or the frame gap is too small, which is easy to cause the conveyor belt to tear, Some problems such as peeling and scratching of the covering glue appear.

In this regard, technicians summarized five methods to reduce and avoid problems

1. Select a suitable conveyor belt

2. Reduce the wear of conveyor parts on conveyor belt.

3. Optimize the structure of the feeding device.

4. Change the material receiving angle to reduce the material impact.

5. Protect the easily worn parts of the belt body.

Miou belt focuses on the production, processing and sales of industrial conveyor belts. It has always provided customers with high-quality conveyor belts. It can be customized according to the material, width, height and perimeter required by customers. New and old customers are welcome to customize.